If you just bought a home theatre system or a couple of speakers, you may want some recommendations on properly setting it up in the event that you don’t desire to hire an installer. You might think you are technically savvy and that installing your brand-new home theatre system is a snap. I will give some recommendations that will help you avoid some commonly made mistakes.
After unpacking your brand-new home theatre system, you will often find one central component in addition to 5 or 7 speakers 音響店. The central component is going to give you the audio for all of your speakers that you are likely to set up. This central component can also be known as surround sound receiver or amplifier. It’s the central hub of your home theater system.
Be sure that you add this receiver in a location that is fairly centrally located to minimize the total amount of speaker wire that you might want to run. You don’t necessarily need to place the receiver right close to your TV. Just ensure it is in a dry and safe place. Also, be sure that it is simple to reach the receiver from your TV or DVD/Blue-ray player since you will need to connect these.
Connecting the receiver to power and to your TV or DVD is pretty straightforward. Most contemporary TVs have an optical output which connects right to your receiver via a fiberoptical cable. This cable may not be incorporated with your system but it is available at any electronics store. However, setting up your speakers can be a bit more tricky.
When you yourself have wireless rear speakers you will not need the maximum amount of speaker cable and the setup will be somewhat easier. To start with, measure how much speaker cable you will need. Be sure to add some extra cable to take into consideration those bends and corners. Select the gauge of the speaker cable depending on how much power you want to drive your speakers with. The higher the energy the thicker the speaker cable. Your subwoofer will often have an integral amp and connect to your receiver via RCA cable.
When connecting the speaker cable, be sure that you connect the cable with the proper polarity. Each speaker has a color coded terminal, usually red and black. Select a speaker cable that shows one strand in a different color than the other. Then connect the cable to all speakers the exact same way. Then, when connecting the speaker cable to your receiver, make certain that you connect the cable to each speaker terminal at the receiver in the exact same manner. This may keep the sound likely to each speaker in the correct phase and optimize your sound experience.
Wireless rear speakers will typically incur an audio delay during transmission. This delay is also referred to as latency. Typically the latency ranges between 1 and 20 ms. For optimum effect, it is better if all of the speakers are in sync. When you yourself have a system that uses wireless rears and wired front speakers, i.e. you’ve a mixture of wireless and wired speakers, you must attempt to delay the audio likely to the wired speakers by the latency of the wireless speakers.
Talk with the maker if your surround receiver can be set to delay the audio of specific channels. If you are using wireless rears, you wish to set the front-speaker and side-speaker channels to delay the audio. Home entertainment systems of not created for wireless rear speakers may not need this capability. In this case you might want to locate a wireless speaker kit that has very low latency, ideally less than 1 ms. This may keep all of your speakers in perfect sync.