If you merely bought a home theater system or a couple of speakers, you may want some tips on properly setting it up if you don’t desire to hire an installer. You may be thinking you’re technically savvy and that installing your new home entertainment system will be a snap. I can give some recommendations that can help you avoid some commonly made mistakes.
After unpacking your new home entertainment system, you will usually find one central component in addition to 5 or 7 speakers 新竹音響店. The central component will give you the audio for your entire speakers which you will set up. This central component can be called surround sound receiver or amplifier. It is the central hub of your home theater system.
Be sure that you put this receiver in a location that’s fairly centrally located to minimize the amount of speaker wire that you might want to run. You don’t necessarily need to put the receiver right close to your TV. Just ensure it is in a dry and safe place. Also, make sure that you can easily reach the receiver from your TV or DVD/Blue-ray player because you should connect these.
Connecting the receiver to power and to your TV or DVD is rather straightforward. Most contemporary TVs have an optical output which connects directly to your receiver via a fiberoptical cable. This cable may not be added with one’s body nonetheless it is available at any electronics store. However, creating your speakers might be a bit more tricky.
When you have wireless rear speakers you won’t need just as much speaker cable and the setup will undoubtedly be somewhat easier. To start with, measure simply how much speaker cable you’ll need. Make sure to then add extra cable to take into account those bends and corners. Select the gauge of the speaker cable depending on what much power you wish to drive your speakers with. The higher the energy the thicker the speaker cable. Your subwoofer will usually have a built-in amp and hook up to your receiver via RCA cable.
When connecting the speaker cable, make sure that you connect the cable with the proper polarity. Each speaker has a shade coded terminal, usually red and black. Select a speaker cable that shows one strand in a different color compared to the other. Then connect the cable to any or all speakers the same way. Then, when connecting the speaker cable to your receiver, make certain that you connect the cable to each speaker terminal at the receiver in the same manner. This can keep carefully the sound likely to each speaker in the right phase and optimize your sound experience.
Wireless rear speakers will typically incur an audio delay during transmission. This delay is also called latency. Usually the latency ranges between 1 and 20 ms. For optimum effect, it is most beneficial if most of the speakers are in sync. When you have a method that uses wireless rears and wired front speakers, i.e. you have a mixture of wireless and wired speakers, you must try to delay the audio likely to the wired speakers by the latency of the wireless speakers.
Talk with the maker if your surround receiver could be set to delay the audio of specific channels. If you should be using wireless rears, you intend to set the front-speaker and side-speaker channels to delay the audio. Home theater systems of not made for wireless rear speakers may not have this capability. In this instance you may want to locate a wireless speaker kit that has very low latency, ideally less than 1 ms. This can keep your entire speakers in perfect sync.